Basic Switch Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create account
config account
show account
delete account
show session
show switch
show serial_port
config serial_port
enable clipaging
disable clipaging
enable telnet
disable telnet
enable web
disable web
enable snmp
disable snmp
save
reboot
reset
login
logout
show config
config configuration
telnet
config terminal line
show terminal line
Each command is listed, in detail, in the following sections.
Parameters
[admin | operator | user] <username 15>
<username>
<username>
baud_rate [9600 | 19200 | 38400 | 115200] auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]
<tcp_port_number 1-65535>
<tcp_port_number 1-65535>
config <config_id1-2>
[config | system]
[ current_config | config_in_nvram <config_ id 1-2> | information]
<config_id 1-2> [active | delete | boot_up]
<ipaddr> {tcp_port <value 0-65535>}
B
ASIC
9
4
S C
WITCH OMMANDS