Mld Snooping Commands - D-Link DGS-1100-16/ME Reference Manual

The Switch supports MLDv1- and MLDv2 awareness (excluded MLDv2 source-filtering) snooping.
The MLD Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable mld_snooping
disable mld_snooping
config mld_snooping
config mld_snooping
querier
create mld_snooping
static_group
config mld_snooping
static_group
delete mld_snooping
static_group
create mld_snooping
multicast_vlan
config mld_snooping
multicast_vlan
delete mld_snooping
multicast_vlan
config mld_snooping
multicast_vlan_group
enable mld_snooping
multicast_vlan
disable mld_snooping
multicast_vlan
show mld_snooping
multicast_vlan
show mld_snooping
multicast_vlan_group
show mld snooping
show mld_snooping
group
show mld_snooping
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[vlan_name <vlan_name 8> | vlanid <vidlist 1-4094> | all] {fast_leave [enable |
disable] | state [enable | disable]}(1)
[vlan_name <vlan_name 8> | vlanid <vidlist 1-4094> | all] state [enable | disable]
[vlan_name<vlan_name 8> | vlanid < vidlist 1-4094> ] <ipv6addr>
[vlan_name <vlan_name 8> | vlanid < vidlist 1-4094> ] < ipv6addr > [ add |
delete] <portlist>
[vlan_name<vlan_name 8> | vlanid < vidlist 1-4094> ] <ipv6addr>
<vlan_name 8> <vlanid 2-4094>
<vlan_name 8> { action [add | delete] [member_port <portlist> | source_port
<portlist> | tag_member_port <portlist >] |state [enable | disable] |
replace_source_ip <ipv6addr> } (1)
[name <vlan_name 8>| all]
<vlan_name 8> [add | delete] ipv6_range <mcast_address_range>
{name <vlan_name 8>}
{name <vlan_name 8>}
[vlan_name <vlan_name 8> | vlanid<vidlist 1-4094> | all]
[all | [vlan_name <vlan_name 8> | vlanid <vidlist 1-4094> | ports <portlist>]
{ipaddress<ipv6addr>}]
[all | [vlan_name <vlan_name 8> | vlanid <vidlist 1-4094>]<ipv6addr>]

MLD SNOOPING COMMANDS

102
19