D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 404

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show loopback ipif
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display loopback IP interface settings.
Used to display the configuration of a loopback IP interface on the
switch.
show loopback ipif {<ipif_name 12>}
The show ipif command displays the configuration of a loopback IP
interface on the switch.
ipif_name - Specifies the name of the loopback IP interface you want
to display. If no parameter is specified, the switch will display all
loopback IP interfaces.
None.
DES-3800:admin# show loopback ipif
Command: show loopback ipif
Loopback IP Interface Settings
Interface Name : loopback0
IP Address : 172.19.10.20
Subnet Mask : 255.255.255.255
Admin. State : Enabled
Link Status : Link UP
Interface Name : loopback1
IP Address : 30.2.2.2
Subnet Mask : 255.255.255.255
Admin. State : Enabled
Link Status : Link UP
Total Entries : 2
DES-3800:admin#
400