Auto Config Commands V3 - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The auto config function enables the Switch to obtain its configuration from a TFTP server upon booting up.
Command
enable autoconfig
disable autoconfig
show autoconfig
Each command is listed, in detail, in the following sections.
enable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable autoconfig.
DES-3800:admin#enable autoconfig
Command: enable autoconfig
Success
DES-3800:admin#
Parameters
Enables the auto-config function and after rebooting, the system will
adopt the configuration file from the tftp server.
enable autoconfig
When this function is enabled, the system ip interface will be changed
to DHCP mode immediately. After rebooting the system it will try to get
the configuration file from the TFTP server, whose information is
configured in the DHCP server. When the system gets the configuration
file from the TFTP server, it will apply the configuration to the system. If
the system fails to get a configuration file, the Switch will use the local
configuration file for booting.
None.
Only Administrator or Operator-level users can issue this command.
A C
UTO
195
28
C
ONFIG OMMANDS
V3