Network Management Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
The xStack DES-3800 Switch Series supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. After
enabling SNMP, you can specify which version of SNMP you want to use to monitor and control the Switch. three versions of SNMP
vary in the level of security provided between the management station and the network device. The following table lists the security
features of the three SNMP versions:
SNMP Authentication
Version Method
v1 Community String
v2c Community String
v3 Username
v3 MD5 or SHA
v3 MD5 DES or SHA DES
The SNMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp authenticate traps
show snmp traps
disable snmp traps
disable snmp authenticate traps
config snmp system_contact
config snmp system_location
config snmp system_name
enable rmon
disable rmon
enable snmp
disable snmp
Each command is listed, in detail, in the following sections.
N
ETWORK
Description
Community String is used for authentication − NoAuthNoPriv
Community String is used for authentication − NoAuthNoPriv
Username is used for authentication − NoAuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA algorithms −
AuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA algorithms −
AuthPriv.
DES 56-bit encryption is added based on the CBC-DES (DES-56) standard
Parameters
<ipaddr> | network <ip_addr/netmask>
<ipaddr> | network <ip_addr/netmask>| all
<sw_contact>
<sw_location>
<sw_name>
50
M
ANAGEMENT
8
C
OMMANDS