D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 84

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show Syslog host information:
DES-3800:admin#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id
-------
1
2
3
Total Entries : 3
DES-3800:admin#
config system_severity
Purpose
Syntax
Description
Parameters
Used to display the syslog hosts currently configured on the Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
None.
Host IP Address Severity
--------------- ----------- --------
10.1.1.2 All
10.40.2.3 All
10.21.13.1 All
To configure severity level of an alert required for log entry or trap
message.
config system_severity [trap | log | all] [critical | warning | information]
This command is used to configure the system severity levels on the
Switch. When an event occurs on the Switch, a message will be sent to the
SNMP agent (trap), the Switch's log or both. Events occurring on the
Switch are separated into three main categories, these categories are NOT
precisely the same as the parameters of the same name (see below).
Information – Events classified as information are basic events
•
occurring on the Switch that are not deemed as problematic, such as
enabling or disabling various functions on the Switch.
Warning - Events classified as warning are problematic events that
•
are not critical to the overall function of the Switch but do require
attention, such as unsuccessful downloads or uploads and failed
logins.
Critical – Events classified as critical are fatal exceptions occurring on
•
the Switch, such as hardware failures or spoofing attacks.
Choose one of the following to identify where severity messages are to be
sent.
•
trap – Entering this parameter will define which events occurring
on the Switch will be sent to a SNMP agent for analysis.
•
log – Entering this parameter will define which events occurring
on the Switch will be sent to the Switch's log for analysis.
Facility UDP port Status
-------- ------
Local0 514
Local0 514
Local0 514
80
Disabled
Disabled
Disabled