D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 319

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config dhcp_relay add ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add an IP destination to the DHCP relay table:
config dhcp_relay delete ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an IP destination from the DHCP relay table:
Used to add an IP destination address to the switch's DHCP/BOOTP
relay table.
config dhcp_relay add ipif <ipif_name 12> <ipaddr>
This command adds an IP address as a destination to which to forward
(relay) DHCP/BOOTP relay packets.
<ipif_name 12> The name of the IP interface in which DHCP relay is to
be enabled.
<ipaddr> The DHCP server IP address.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#config dhcp_relay add ipif System
10.58.44.6
Command: config dhcp_relay add ipif System
10.58.44.6
Success.
DES-3800:admin#
Used to delete one or all IP destination addresses from the Switch's
DHCP/BOOTP relay table.
config dhcp_relay delete ipif <ipif_name 12> <ipaddr>
This command is used to delete an IP destination addresses in the
Switch's DHCP/BOOTP relay table.
<ipif_name 12> The name of the IP interface that contains the IP
address below.
<ipaddr> The DHCP server IP address.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#config dhcp_relay delete ipif System
10.58.44.6
Command: config dhcp_relay delete ipif System
10.58.44.6
Success.
DES-3800:admin#
315