D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 268

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show authen application
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the login and enable method list for all applications on the Switch:
DES-3800:admin#show authen application
Command: show authen application
Application
-----------
Console
Telnet
SSH
HTTP
DES-3800:admin#
create authen server_host
Purpose
Syntax
Description
Parameters
Used to display authentication methods for the various applications
on the Switch.
show authen application
This command will display all of the authentication method lists (login,
enable administrator privileges) for Switch configuration applications
(console, telnet, ssh, web) currently configured on the Switch.
None.
None.
Login Method List
------------------
default
Trinity
default
default
Used to create an authentication server host.
create authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius] {port <int 1-65535> | key [<key_string 254> |
none] | timeout <int 1-255> | retransmit < 1-255>}
This command will create an authentication server host for the
TACACS/XTACACS/TACACS+/RADIUS security protocols on the
Switch. When a user attempts to access the Switch with
authentication protocol enabled, the Switch will send authentication
packets to a remote TACACS/XTACACS/TACACS+/RADIUS server
host on a remote host. The TACACS/XTACACS/TACACS+/RADIUS
server host will then verify or deny the request and return the
appropriate message to the Switch. More than one authentication
protocol can be run on the same physical server host but, remember
that TACACS/XTACACS/TACACS+/RADIUS are separate entities
and are not compatible with each other. The maximum supported
number of server hosts is 16.
server_host <ipaddr> - The IP address of the remote server host to
add.
protocol – The protocol used by the server host. The user may
choose one of the following:
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes the
TACACS+ protocol.
264
Enable Method List
------------------
default
default
default
default