Mld Snooping Commands - D-Link DGS-510 Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide

47. MLD Snooping Commands

47-1 clear ipv6 mld snooping statistics
This command is used to clear the statistic counter of the Switch.
clear ipv6 mld snooping statistics {all | vlan VLAN-ID | interface INTERFACE-ID}
Parameters
all
vlan VLAN-ID
interface INTERFACE-ID
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to clear the statistic counter of the Switch.
Example
This example shows how to clear all MLD snooping statistics.
Switch# clear ipv6 mld snooping statistics all
Switch#
47-2 ipv6 mld snooping
This command is used to enable or disable MLD snooping.
ipv6 mld snooping
no ipv6 mld snooping
Parameters
None.
Default
MLD snooping is disabled on all VLAN interfaces.
The MLD snooping global state is disabled by default.
Command Mode
Interface Configuration Mode.
Global Configuration Mode.
Specifies to clear IPv6 MLD snooping statistics for all VLANs and all
ports.
Specifies the VLAN used. If no VLAN is specified, statistics for all
VLANs are cleared.
Specifies the interface used.
408