D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 66

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Example usage:
To view the current configuration settings:
DES-3800:admin#show config current_config
Command: show config current_config
#---------------------------------------------------------------
#
#
#
#Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
#---------------------------------------------------------------
# DOUBLE_VLAN
Diable double_vlan
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
enable telnet 23
enable web 80
# BNR
config command_prompt default
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
Example usage:
To view saved configuration file information saved on the Switch:
DES-3800:admin#show config information
Command: show config information
ID Version
-- -------
*1 4.05.B08
2 (empty)
Note: * indicates the next boot up configuration
(T) means configuration update through TELNET
(S) means configuration update through SNMP
(W) means configuration update through WEB
DES-3800:admin#
config configuration
Purpose
Syntax
Description
Parameters
DES-3828 Configuration
Firmware: Build 4.50-B10
Size(B) Update Time
------ ------------
12961 2006/08/30 09:36:10
Used to configure the configuration section as a boot up section, or to
delete the firmware section
config configuration <config_id 1-2> [boot_up | active | delete]
This command is used to configure the configuration section. The user
may choose to remove the configuration section, use it as a boot up or
active section.
<config_id 1-2> – Specifies the working section. The Switch can hold two
firmware versions for the user to select from, which are specified by
configuration ID.
boot_up – Entering this parameter will specify the configuration ID as a
From
-------
Local Saved
62
User
-----------