D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 20

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
DES-3800:admin#show serial_port
Command: show serial_port
DES-3800:admin#
config serial_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure baud rate:
enable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the feature that allows the screen to be paused when the show command output reaches the end of the page:
Baud Rate : 9600
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
Used to configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
This command is used to configure the serial port's baud rate and auto
logout settings.
baud_rate [9600 | 19200 | 38400 | 115200]− The serial bit rate that will be
used to communicate with the management host. There are four options:
9600, 19200, 38400, 115200.
auto_logout [never | 2_minutes | 5_minutes |10_minutes | 15_minutes
Only Administrator-level users can issue this command.
DES-3800:admin#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DES-3800:admin#
Used to enable the feature that pauses the scrolling of the console
screen when the show command displays more than one page.
enable clipaging
This command enables the screen to be paused when the show
command output reaches the end of the page. The default setting is
enable.
None.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#enable clipaging
Command: enable clipaging
Success.
16