D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 163

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config access_profile profile_id (ipv6)
Restrictions
Example usage:
To configure a previously created access profile based on IPv6 classification:
DES-3800:admin# config access_profile profile_id 4 add
access_id 1 ipv6 class 1 flowlabel 0xABCD port 1:4 deny
Command: config access_profile profile_id 4 add
access_id 1 ipv6 class 1 flowlabel 0xABCD port 1:4 deny
Success.
DES-3800:admin#
specified. The beginning and end of the port list range are separated
by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order.
permit – Specifies that packets that match the access profile are
permitted to be forwarded by the Switch.
priority <value 0-7> − This parameter is specified to re-write
•
the 802.1p default priority previously set in the Switch, which is
used to determine the CoS queue to which packets are
forwarded to. Once this field is specified, packets accepted by
the Switch that match this priority are forwarded to the CoS
queue specified previously by the user.
{replace_priority} − Enter this parameter to re-write the 802.1p
•
default priority of a packet to the value entered in the Priority
field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority
re-written to its original value before being forwarded by the
Switch.
deny – Specifies that packets that match the access profile are not
permitted to be forwarded by the Switch and will be filtered.
delete access_id <value 1-65535> − Use this command to delete a
specific rule from the IPv6 profile. Up to 65535 rules may be
specified for the IPv6 access profile.
Only Administrator or Operator-level users can issue this command.
159