Traffic Segmentation Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Traffic segmentation allows you to further sub-divide VLANs into smaller groups of ports that will help to reduce traffic on the
VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied.
Command
config traffic_segmentation
show traffic_segmentation
Each command is listed, in detail, in the following sections.
config traffic_segmentation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3800:admin# config traffic_segmentation 1-10
forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list
11-15
Success.
DES-3800:admin#
Parameters
<portlist> forward_list [null | <portlist>]
{<portlist>}
Used to configure traffic segmentation on the Switch.
config traffic_segmentation <portlist> forward_list [null | <portlist>]
The config traffic_segmentation command is used to configure traffic
segmentation on the Switch.
<portlist> − Specifies a port or range of ports that will be configured for traffic
segmentation.
forward_list − Specifies a range of ports that will receive forwarded frames from
the ports specified in the portlist, above.
• null − No ports are specified
• <portlist> − Specifies a range of ports for the forwarding list. This list
must be on the same Switch previously specified for traffic
segmentation (i.e. following the <portlist> specified above for config
traffic_segmentation).
Only Administrator or Operator-level users can issue this command.
T S
RAFFIC EGMENTATION
164
20
C
OMMANDS