D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 189

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config route redistribute dst rip src
Restrictions
Example usage:
To configure route redistributions:
DES-3800:admin#config route redistribute dst ospf src rip mettype
type_1 metric 2
Command: config route redistribute dst ospf src rip mettype type_1
metric 2
Success.
DES-3800:admin#
delete route redistribute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete route redistribution settings:
•
inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
•
inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value 0-16> − Allows the entry of an OSPF interface cost. This is
analogous to a Hop Count in the RIP routing protocol.
Only Administrator or Operator-level users can issue this command.
Used to delete an existing route redistribute configuration on the Switch.
delete route redistribute {dst [rip | ospf] src [rip | static | local | ospf]}
This command will delete the route redistribution settings on this switch.
dst [rip | ospf] − Allows the selection of the protocol on the destination
device. The user may choose between RIP and OSPF.
src [rip | static | local | ospf] − Allows the selection of the protocol on the
source device. The user may choose between RIP, static, local or OSPF.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#delete route redistribute dst rip
src ospf
Command: delete route redistribute dst rip src
ospf
Success.
DES-3800:admin#
185