Switch Port Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
config ports
Purpose
Syntax
Description
Parameters
Restrictions
Parameters
[ <portlist> | all ] { medium_type[fiber|copper]} { speed [auto | 10_half | 10_full | 100_half
| 100_full | 1000_full] | flow_control [enable | disable] | learning [enable |
disable ] | state [enable | disable ] | description [ <desc 0-32> | clear ] }
{<portlist>} {[description} | err_disabled]}
Used to configure the Switch's Ethernet port settings.
config ports [ <portlist> | all ] { medium_type[fiber|copper]} { speed [auto | 10_half |
10_full | 100_half | 100_full | 1000_full] | flow_control [enable | disable] | learning
[enable | disable ] | state [enable | disable ] | description [ <desc 0-32> | clear ] }
This command allows for the configuration of the Switch's Ethernet ports. Only the ports
listed in the <portlist> will be affected.
<portlist> − Specifies a port or range of ports to be configured.
all − Configure all ports on the Switch.
medium_type - Specify the medium type when the configured ports are combo ports. This
is an optional parameter for configuring the medium type of the combo port. For non-
combo ports the user does not need to specify the medium_type in the command
speed – Allows the user to adjust the speed for a port or range of ports. The user has a
choice of the following:
auto − Enables auto-negotiation for the specified range of ports.
10_half- Configures the specified range of ports to operate at 10mbps half-duplex.
10_full- Configures the specified range of ports to operate at 10mbps full-duplex.
100_half- Configures the specified range of ports to operate at 100mbps half-duplex.
100_full- Configures the specified range of ports to operate at 100mbps full-duplex.
1000_full − Gigabit ports are statically set to 1000 and cannot be set to slower speeds.
flow_control [enable | disable] – Enables or disables flow control for the specified ports.
learning [enable | disable] − Enables or disables the MAC address learning on the
specified range of ports.
state [enable | disable] − Enables or disables the specified range of ports.
description <desc 32> - Enter an alphanumeric string of no more than 32 characters to
describe a selected port interface. "clear" is a keyword in this cli command. So string
"clear" is not allowed.
clear - Enter this command to clear the port description of the selected port(s).
Only Administrator or Operator-level users can issue this command.
S
WITCH
27
5
P C
ORT OMMANDS