D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 194

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show rip
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display RIP configuration:
DES-3800:admin#show rip
Command: show rip
RIP Global State : Disabled
Update Interval : 30 seconds
Timeout Interval : 180 seconds
Garbage-collection Interval : 120 seconds
RIP Interface Settings
Interface
State
------------- ----------------
System
Total Entries : 1
DES-3800:admin#
Example usage:
To display RIP configurations by IP interface:
DES-3800:admin#show rip ipif System
Command: show rip ipif System
RIP Interface Settings
Interface Name: System
IP Address/Netmask: 10.53.13.33/8 (Link Up)
Interface Metric: 1 (Default)
Administrative State: Disabled
TX Mode: V2 Only
RX Mode: V1 or V2
Authentication: Disabled
Total Entries: 1
DES-3800:admin#
Used to display the RIP configuration and statistics for the Switch.
show rip {ipif <ipif_name 12>}
This command will display the RIP configuration and statistics for a given
IP interface or for all IP interfaces.
ipif <ipif_name 12> − The name of the IP interface for which to display the
RIP configuration and settings. If this parameter is not specified, the show
rip command will display the global RIP configuration for the Switch.
None.
IP Address/Netmask
10.41.44.33/8
TX Mode RX Mode
-------- --------
V2 Only V1 or V2
190
Authen- State
tication
-------- --------
Disabled Disabled