D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 146

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
DES-3800:admin#
config 802.1x guest_vlan ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the ports for a previously created 802.1x Guest VLAN as enabled.
DES-3800:admin#config 802.1x guest_vlan ports 1-5 state
enable
Command: config 802.1x guest_vlan ports 1-5 state enable
Success.
DES-3800:admin#
show 802.1x guest_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the configurations for a previously created 802.1x Guest VLAN.
Used to configure ports for a pre-existing 802.1x guest VLAN.
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
The config 802.1x guest_vlan ports command is used to configure ports to
be enabled or disabled for the 802.1x guest VLAN.
<portlist> - Specify a port or range of ports to be configured for the 802.1x
Guest VLAN.
all – Specify this parameter to configure all ports for the 802.1x Guest VLAN.
state [enable | disable] – Use these parameters to enable or disable port
listed here as enabled or disabled for the 802.1x Guest VLAN.
Only Administrator or Operator-level users can issue this command. This
VLAN is only supported for port-based 802.1x and must have already been
previously created using the create vlan command. If the specific port state
changes from an enabled state to a disabled state, these ports will return to
the default VLAN.
Used to view the configurations for a 802.1x Guest VLAN.
show 802.1x guest_vlan
The show 802.1x guest_vlan command is used to display the
settings for the VLAN that has been enabled as an 802.1x Guest
VLAN. Guest 802.1X VLAN clients are those who have not been
authorized for 802.1x or they haven't yet installed the necessary
802.1x software, yet would still like limited access rights on the
Switch.
None.
Only Administrator or Operator-level users can issue this command.
This VLAN is only supported for port-based 802.1x and must have
already been previously created using the create vlan command.
Only one VLAN can be set as the 802.1x Guest VLAN.
142