Network Monitoring Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
config system_severity
show system_severity
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
N
Parameters
<portlist>
<portlist>
[cpu | ports {<portlist>}]
{ports <portlist>}
index <value 1-65535>
<index 1-4> ipaddress <ipaddr> {severity [informational | warning |
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number>| state [enable | disable]
[all | <index 1-4>] {severity [informational | warning | all] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable
| disable]}
[<index 1-4> | all]
{<index 1-4>}
[trap | log | all] [critical | warning | information]
Used to display statistics about the packets sent and received by the
Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and
received by ports specified in the <portlist>.
<portlist> − Specifies a port or range of ports to be displayed.
None.
69
M
ETWORK ONITORING
10
C
OMMANDS