Jumbo Frame Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Certain switches can support jumbo frames (frames larger than the standard Ethernet frame size of 1536 bytes). To transmit frames of
up to 9K (and 9220 bytes tagged), the user can increase the maximum transmission unit (MTU) size from the default of 1536 by
enabling the Jumbo Frame command.
The jumbo frame commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
Each command is listed, in detail, in the following sections.
enable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
disable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
Parameters
Used to enable the jumbo frame function on the Switch.
enable jumbo_frame
This command will allow ethernet frames larger than 1536 bytes to be
processed by the Switch. The maximum size of the jumbo frame may
not exceed 9220 bytes.
None.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#enable jumbo_frame
Command: enable jumbo_frame
Success.
DES-3800:admin#
Used to disable the jumbo frame function on the Switch.
disable jumbo_frame
This command will disable the jumbo frame function on the Switch.
None.
Only Administrator or Operator-level users can issue this command.
J
UMBO
250
38
F C
RAME OMMANDS