D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 326

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
create address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create address binding on the Switch:
DES-3800:admin#create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DES-3800:admin#
To create address binding on the Switch for ACL mode:
DES-3800:admin#create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04 mode acl
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04 mode acl
Success.
DES-3800:admin#
Once the ACL mode has been created and enabled (without previously created access profiles), the access profile table will look like
this:
Used to create an IP-MAC Binding entry.
create address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all] | mode {arp | acl]}
This command will create an IP-MAC Binding entry.
<ipaddr> The IP address of the device where the IP-MAC binding is
made.
<macaddr> The MAC address of the device where the IP-MAC binding
is made.
<portlist> - Specifies a port or range of ports to be configured for
address binding.
all – Specifies that all ports on the switch will be configured for address
binding.
mode – The user may set the mode for this IP-MAC binding settings by
choosing one of the following:
•
arp - Choosing this selection will set a normal IP-MAC
Binding entry for the IP address and MAC address entered. If
the system is in ARP mode, the arp mode entries and acl
mode entries will be effective. If the system is in the acl
mode, only the acl mode entries will be active.
•
acl - Choosing this entry will allow only packets from the
source IP-MAC binding entry created here. All other packets
with a different IP address will be discarded by the Switch.
This mode can only be used if the ACL Mode has been
enabled in the IP-MAC Binding Ports window as seen
previously.
Only Administrator or Operator-level users can issue this command.
322