D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 70

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
disable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To stop the autoconfiguration function:
show autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To upload an autoconfiguration-:
ping
Purpose
Syntax
Description
Parameters
Use this to deactivate autoconfiguration from DHCP.
disable autoconfig
This instructs the Switch not to accept autoconfiguration instruction from the
DHCP server. This does not change the IP settings of the Switch. The ipif
settings will continue as DHCP client until changed with the config ipif
command.
None.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#disable autoconfig
Command: disable autoconfig
Success.
DES-3800:admin#
Used to display the current autoconfig status of the Switch.
show autoconfig
This will list the current status of the autoconfiguration function.
None.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#show autoconfig
Command: show autoconfig
Autoconfig disabled.
Success.
DES-3800:admin#
Used to test the connectivity between network devices.
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
The ping command sends Internet Control Message Protocol (ICMP)
echo messages to a remote IP address. The remote IP address will
then "echo" or return the message. This is used to confirm
connectivity between the Switch and the remote device.
<ipaddr> - Specifies the IP address of the host.
66