Limited Multicast Ip Address Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The Limited Multicast IP Address commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
create mcast_filter_profile profile_id
config mcast_filter_profile profile_id
delete mcast_filter_profile profile_id
show mcast_filter_profile
config limited_multicast_addr ports
show limited_multicast_addr
config max_mcast_group ports
show max_mcast_group ports
Each command is listed, in detail, in the following sections.
create mcast_filter_profile
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create a multicast filter profile:
L
IMITED
This command creates a multicast address profile.
create mcast_filter_profile profile_id <value 1-24> description
<desc 1-32>
This command configures a multicast address profile. Mutliple ranges
of multicast addresses can be defined in the profile.
profile_id - ID of the profile. Range is 1 to24.
description - Provides a meaningful description for the profile.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin# create mcast_filter_profile profile_id
2 description MOD
Command: create mcast_filter_profile profile_id 2
description MOD
Success.
DES-3800:admin#
M
ULTICAST
Parameters
<value 1-24> description <desc 1-32>
< value 1-24> { description <desc 1-32> | [add |
delete ] <mcast_address_list>}
<value 1-24>
{ profile_id <value 1-24>}
<portlist> { [add | delete ] profile_id <value 1-24> |
access [permit | deny]}
{ ports <portlist>}
<portlist> max_group <value 1-256>
{ports <portlist>}
364
IP A C
DDRESS
54
OMMANDS