D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 32

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Example usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, with learning and state enabled:
DES-3800:admin#config ports 1-3 speed 10_full learning enable state
enable
Command: config ports 1-3 speed 10_full learning enable state enable
Success.
DES-3800:admin#
NOTE:Combo ports prefer to use Fiber cabling. The following are the modes that the user can
use to configure the Giga port.
<Fiber Mode> - Auto, 1000Full
<Copper Mode> - Auto, 100Full/Half, 10Full/Half
show ports
Purpose
Syntax
Description
Parameters
Restrictions
Used to display the current configuration of a range of ports.
show ports {<portlist>} {[description} | err_disabled]}
This command is used to display the current configuration of a
range of ports.
<portlist> − Specifies a port or range of ports to be displayed.
description – Adding this parameter to the show ports command
indicates that a previously entered port description will be included
in the display.
err_disabled – Choosing this parameter will display ports that have
been disconnected due to an error on the port, such as a Loopback
Detection.
None.
28