D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 344

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config cpu access_profile
•
•
igmp − Specifies that the Switch will examine the Internet Group Management Protocol
(IGMP) field within each packet.
•
tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP) field
within each packet.
•
•
protocol_id <value 0-255> − Specifies that the switch will examine the Protocol field in
each packet and if this field contains the value entered here, apply the following rules.
udp − Specifies that the Switch will examine the User Datagram Protocol (UDP) field
within each packet.
•
•
protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field in
each packet and if this field contains the value entered here, apply the following rules.
protocol ID and the mask options behind the IP header.
packet_content_mask – Specifies that the Switch will mask the packet header beginning
with the offset value specified as follows:
31.
47.
63.
79.
permit | deny – Specify that the packet matching the criteria configured with command will
either be permitted entry to the CPU or denied entry to the CPU.
delete access_id <value 1-65535> - Use this to remove a previously created access rule
in a profile ID.
Only Administrator or Operator-level users can issue this command.
Restrictions
type <value 0-255> − Specifies that the access profile will apply to this ICMP
type value.
code <value 0-255> − Specifies that the access profile will apply to this ICMP
code.
type <value 0-255> − Specifies that the access profile will apply to packets that
have this IGMP type value.
src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP source port in their TCP header.
dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP destination port in their TCP header.
src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP source port in their header.
dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP destination port in their header.
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP
•
offset_0-15 - Enter a value in hex form to mask the packet from byte 0 to byte 15.
•
offset_16-31 - Enter a value in hex form to mask the packet from byte 16 to byte
•
offset_32-47 - Enter a value in hex form to mask the packet from byte 32 to byte
•
offset_48-63 - Enter a value in hex form to mask the packet from byte 48 to byte
•
offset_64-79 - Enter a value in hex form to mask the packet from byte 64 to byte
•
340