Limited Ip Multicast Address Commands - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
The Limited IP Multicast Address command allows the administrator to permit or deny access to a port or range of ports by
specifying a range of multicast addresses. The limited IP multicast address commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
create mcast_filter_profile profile_id
config mcast_filter_profile
delete mcast_filter_profile
delete mcast_filter_profile
show mcast_filter_profile
config limited_multicast_addr ports
show limited_multicast_addr ports
config max_mcast_group port
show max_mcast_group ports
Each command is listed, in detail, in the following sections.
create mcast_filter_profile profile_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an mcast filter profile:
DES-3028P:4#
profile_name MOD
Command: create mcast_filter_profile profile_id 2 profile_name
MOD
Success.
DES-3028P:4#
L IP M
IMITED
Parameters
<value 1-24> profile_name <name 1-32>
[profile_id < value 1-24>| profile_name <name 1-32> ] {
profile_name <name 1-32> | [add | delete ]
<mcast_address_list>}
[profile_id [<value 1-24> | all]
profile_name <name 1-32>
{ [profile_id <value 1-24>|profile_name <name 1-32>]}
<portlist> {[add | delete ] [profile_id <value 1-24> |
profile_name <name 1-32> ] }
{<portlist>}
<portlist> max_group [<value 1-256>]
{ <portlist>}
This command creates a multicast address profile.
create mcast_filter_profile profile_id <value 1-24> profile_name
<name 1-32>
This command creates a multicast address profile. Multiple ranges of
multicast addresses can be defined in the profile.
profile_id  ID of the profile. Range is 1 to 24.
profile_name  Provides a meaningful description for the profile
Only Administrator-level users can issue this command.
create mcast_filter_profile
A
ULTICAST DDRESS
287
42
C
OMMANDS
profile_id 2