Route Redistribution Commands - D-Link DES-6500 Command Line Interface Reference Manual

The Route Redistribution commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
create route redistribute dst
ospf
create route redistribute dst
rip
config route redistribute dst
ospf
config route redistribute dst
rip
delete route redistribute
show route redistribute
Each command is listed, in detail, in the following sections.
create route redistribute dst ospf
Purpose
Syntax
Description
Parameters
Restrictions
Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing information
will be redistributed to OSPF.
Route Source
RIP
Static
R
OUTE
Parameters
src [static/rip/local]
mettype [1/2]
metric <value 0-16777214>
[local | static | ospf {all | internal | external | extType1 | extType2 |
inter+e1 | inter+e2}] {metric <value 0-16>}
src [static/rip/local]
mettype [1/2]
metric <value 0-16777214>
[local | static | ospf {all | internal | external | extType1 | extType2 |
inter+e1 | inter+e2}] {metric <value 0-16>}
dst [rip/ospf]
src [local/static/ospf]
dst [rip/ospf]
src [rip/static/local/ospf]
Used to add route redistribution settings for the exchange of RIP routes
to OSPF routes on the switch.
create route redistribute dst ospf src [static|rip|local] {mettype
[1|2]|metric <value 0-16>}
This command will redistribute routing information between the OSPF
and RIP routing protocols to all routers on the network that are running
OSPF or RIP. Routing information entered into the Static Routing Table
on the local DES-6500 switch is also redistributed.
src [static/rip/local] − Allows for the selection of the protocol for the
source device.
mettype [1/2] − Allows for the selection of one of two methods of
calculating the metric value. Type-1 calculates (for RIP to OSPF) by
adding the destination's interface cost to the metric entered in the Metric
field. Type-2 uses the metric entered in the Metric field without change.
this field applies only when the destination field is OSPF.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Metric
0 to 16777214
0 to 16777214
R
EDISTRIBUTION
Metric Type
mettype 1
mettype 2
mettype 1
26
C
OMMANDS