Route Redistribution Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

Route Redistribution Commands

The route redistribution commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
create route redistribute
dst ospf src
create route redistribute
dst rip src
config route redistribute
dst ospf src
config route redistribute
dst rip src
delete route redistribute
show route redistribute
Each command is listed, in detail, in the following sections.
create route redistribute dst ospf src
Purpose
Syntax
Description
Parameters
Restrictions
Routing information source − RIP. the Static Route table, and the Local interface routing information.
Routing information will be redistributed to OSPF.
Parameters
[ static| rip| local] {mettype [ 1 | 2] |metric <value 0-16777214> }
[ local | static | ospf { all |internal | external | type_1 | type_2 |
inter+e1| inter+e2 } ]{metric <value 0-16>}
[ static| rip| local] {mettype [1|2] |metric <value 0-16777214> }
[ local | static | ospf { all | internal | external | type_1 | type_2 |
inter+e1| inter+e2} ]{metric <value 0-16>}
[dst [rip|ospf] src [rip|static|local|ospf]]
{dst [rip|ospf] | src [rip|static|local|ospf]}
Used to add route redistribution settings for the exchange of RIP
routes to OSPF routes on the Switch.
create route redistribute dst ospf src [ static| rip| local]
{mettype [ 1 | 2] |metric <value 0-16777214> }
This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local xStack switch is also redistributed.
src [static | rip | local] − Allows for the selection of the protocol for
the source device.
mettype [1 | 2] − Allows for the selection of one of two methods of
calculating the metric value.
Type-1 calculates (for RIP to OSPF) by adding the destination's
interface cost to the metric entered in the Metric field.
Type-2 uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
metric <value 0-16777214> − Allows the entry of an OSPF interface
cost. This is analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Route Source
RIP
Metric
0 to 16777214
208
Metric Type
mettype 1
30