Signal Quality Indicators; Ethernet Link And Activity - Digi IX10 User Manual

Digi IX10 hardware reference
Flashing white
ETH port connection established and in
the process of connecting to the
cellular network.
Flashing green
Connected to 2G or 3G and is in the
process of connecting to any device on
its ETH port, or nothing is connected to
the port.

Signal quality indicators

LEDs labeled 1 through 5 Indicate the cellular service quality level.
Signal bars
The weighted dBm measurements are negative numbers, meaning the smaller negative values
denote a larger number. For example, a -85 is a better signal than -90.
Note See Signal quality bars explained
calculated and subsequently displayed via the LED indicators.

Ethernet Link and Activity

The LEDs on the ETH port indicate that the Ethernet network interface is up and there is activity on
the network interface.
Left LED (on top of port connector)
Off: No Ethernet link detected.
n
Blinking amber: Indicates Ethernet traffic.
n
Right LED (on top of port connector)
IX10 User Guide
Weighted dBm
-113 to -99
-98 to -87
-86 to -76
-75 to -64
-63 to -51
for more information regarding how signal strength is
Solid blue
Connected to the 4G LTE and also has a
ETH connection.
Alternating Red/yellow (or orange)
Upgrading firmware.
WARNING! DO NOT POWER
OFF DURING FIRMWARE
UPGRADE.
Signal strength %
0% to 23%
24% to 42%
43% to 61%
62% to 80%
81% to 100%
IX10 LEDs
Quality
Bad
Marginal
OK
Good
Excellent
23