Danfoss VLT AutomationDrive FC 360 Programming Manual page 87

Programming Guide | VLT® AutomationDrive FC 360
2-39 Mech. Brake w/ dir. Change
Default value:
[0] OFF
Setup:
All setups
Data type:
Uint8
Enable or disable the mechanical brake function when the shaft changes direction.
Option
[0]
[1]
[2]
Parameter Group 3-** Reference/Ramps
4.4
3-0* Reference Limits
4.4.1
Parameters for setting the reference unit, limits, and ranges.
3-00 Reference Range
Default value:
[0] Min - Max
Setup:
All setups
Data type:
Uint8
Select the range of the reference signal and the feedback signal.
Option
[0]
[1]
3-01 Reference/Feedback Unit
Default value:
Size related
Setup:
All setups
Data type:
Uint8
Select the unit to be used in Process PID Control references and feedback.
Danfoss A/S © 2024.01
Parameter type:
Conversion index:
Change during operation:
Name
OFF
ON
ON with start delay
Parameter type:
Conversion index:
Change during operation:
Name
Min - Max
-Max - +Max
Parameter type:
Conversion index:
Change during operation:
Option
–
True
Description
Disable the mechanical brake function
when the shaft changes direction.
Enable the mechanical brake function
when the shaft changes direction.
The start delay time is set in parameter
1-71 Start Delay.
Option
–
True
Description
Select the range of the reference signal
and the feedback signal. Signal values can
be positive only, or positive and negative.
For both positive and negative values
(both directions), relative to parameter
4-10 Motor Speed Direction.
Option
–
True
AU275649936274en-001401 / 130R0507 |
85