Danfoss VLT AutomationDrive FC 360 Programming Manual page 304

Programming Guide | VLT® AutomationDrive FC 360
Option
[4]
[5]
[7]
[8]
[9]
[12]
[13]
[20]
[25]
37-19 Pos. New Index
Default value:
0
Setup:
1 setup
Data type:
Uint8
302
| Danfoss A/S © 2024.01
Name
Positive SW Limit Exceeded
Negative SW Limit Exceeded
Brake Wear Limit Exceeded
Quick Stop
Tracking Error Limit Exceeded
Reverse Operation
Forward Operation
Home Position Not Found
Tuning Timeout
Parameter type:
Conversion index:
Change during operation:
Description
Check if the value in parameter 34-50
Actual Position exceeds the value in
parameter 33-42 Positive Software Limit,
move in the opposite position.
Check if the value in parameter 34-50
Actual Position exceeds the value in
parameter 33-41 Negative Software Limit,
move in the opposite position.
If the motor is stopped and the brake is
closed, but the value in parameter 34-50
Actual Positionhas a move exceeded the
value in parameter 37-11 Pos. Brake Wear
Limit, check the mechanical brake.
Set by command from DI or bus.
Command position and parameter 34-50
Actual Position difference is greater than
parameter 32-67 Max. Tolerated Position
Error. Increase the value of parameter
32-67 Max. Tolerated Position Error
or check the settings about position
feedback.
Check if parameter 37-15 Pos. Direction
Block has been set to [1] Block Reverse,
move in the opposite position or set
parameter 37-15 Pos. Direction Block to
[0] No Blocking.
Check if parameter 37-15 Pos. Direction
Block has been set to [2] Block Forward,
move in the opposite position or set
parameter 37-15 Pos. Direction Block to
[0] No Blocking.
The home position is not found.
After the speed ramping down, the
position is turned into the target window.
In this state, if the time set in parameter
37-09 Pos. Max Tuning Time is exceeded,
ALARM 120, Position Control Fault is
reported and the reason shown here is
[25] Tuning Timeout.
Range (0–255)
0
True
AU275649936274en-001401 / 130R0507