Danfoss VLT AutomationDrive FC 360 Programming Manual page 260

Programming Guide | VLT® AutomationDrive FC 360
Setup:
1 setup
Data type:
Uint16
View the inverter nominal current, which should match the nameplate data on the connected motor. The data is used for calculation of
torque and motor overload protection.
16-37 Inv. Max. Current
Default value:
0.00 A
Setup:
1 setup
Data type:
Uint16
View the inverter maximum current, which should match the nameplate data on the connected motor. The data is used for calculation of
torque and motor overload protection.
16-38 SL Controller State
Default value:
0
Setup:
1 setup
Data type:
Uint8
View the state of the event under execution by the SL Controller.
16-39 Control Card Temp.
Default value:
0 °C
Setup:
All setups
Data type:
Uint16
View the temperature on the control card, stated in °C.
16-48 Speed Ref. After Ramp [RPM]
Default value:
0 RPM
Setup:
All setups
Data type:
Int32
Define the reference given to the drive after the speed ramp in RPM.
16-5* Ref. & Feedb.
4.15.4
16-50 External Reference
Default value:
0.0%
Setup:
1 setup
Data type:
Int16
View the total reference, the sum of digital, analog, preset, bus, and freeze references, plus catch up and slow down.
258
| Danfoss A/S © 2024.01
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
-2
True
Range (0.00–655.35 A)
-2
True
Range (0–20)
0
True
Range (0–65535 °C)
0
False
Range (-30000–30000 RPM)
0
False
Range (-200.0–200.0%)
-1
True
AU275649936274en-001401 / 130R0507