Danfoss VLT AutomationDrive FC 360 Programming Manual page 192

Programming Guide | VLT® AutomationDrive FC 360
Option
[1693]
[1694]
[1695]
[1697]
[1837]
[1838]
[1839]
[1855]
[1856]
[1866]
[1888]
[3421]
[3422]
[3423]
[3424]
[3425]
[3426]
[3427]
[3428]
[3429]
[3430]
[3450]
[3456]
9-18 Node Address
Default value:
126
Setup:
1 setup
Data type:
Uint8
Enter the station address in this parameter or, alternatively, in the hardware switch. To adjust the station address in parameter 9-18 Node
Address, set the hardware switch to 126 or 127 (that is all switches set to on). Otherwise, this parameter shows the actual setting of the
switch.
9-19 Drive Unit System Number
Default value:
1037
190
| Danfoss A/S © 2024.01
Name
Warning Word 2
Ext. Status Word
Ext. Status Word 2
Alarm Word 3
Temp. Input X48/4
Temp. Input X48/7
Temp. Input X48/10
Active Alarm Number
Active Warning Number
Switching Frequency
Motor current
PCD 1 Read For Application
PCD 2 Read For Application
PCD 3 Read For Application
PCD 4 Read For Application
PCD 5 Read For Application
PCD 6 Read For Application
PCD 7 Read For Application
PCD 8 Read For Application
PCD 9 Read For Application
PCD 10 Read For Application
Actual Position
Track Error
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Range (1–126)
0
True
Range (0–65535)
AU275649936274en-001401 / 130R0507