Danfoss VLT AutomationDrive FC 360 Programming Manual page 203

Programming Guide | VLT® AutomationDrive FC 360
Setup:
All setups
Data type:
Uint16
Provide information about the DO (drive object). This parameter is for PROFINET only.
9-80 Defined Parameters (1)
Default value:
0
Setup:
All setups
Data type:
Uint16
Show a list of all the defined drive parameters.
9-81 Defined Parameters (2)
Default value:
0
Setup:
All setups
Data type:
Uint16
Show a list of all the defined drive parameters.
9-82 Defined Parameters (3)
Default value:
0
Setup:
All setups
Data type:
Uint16
Show a list of all the defined drive parameters.
9-83 Defined Parameters (4)
Default value:
0
Setup:
All setups
Data type:
Uint16
Show a list of all the defined drive parameters.
9-84 Defined Parameters (5)
Default value:
0
Setup:
All setups
Data type:
Uint16
Show a list of all the defined drive parameters.
9-85 Defined Parameters (6)
Default value:
0
Danfoss A/S © 2024.01
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
AU275649936274en-001401 / 130R0507 |
0
True
Range (0–9999), Array [116]
0
False
Range (0–9999), Array [116]
0
False
Range (0–9999), Array [116]
0
False
Range (0–9999), Array [116]
0
False
Range (0–9999), Array [116]
0
False
Range (0–9999), Array [116]
201