Danfoss VLT AutomationDrive FC 360 Programming Manual page 129

Programming Guide | VLT® AutomationDrive FC 360
Option
[42]
[43]
[45]
[46]
[47]
[55]
[56]
[60]
[61]
[62]
[63]
[64]
[65]
[70]
[71]
[72]
Danfoss A/S © 2024.01
Name
Above ref, high
Extended PID Limit
Bus ctrl.
Bus control, timeout: On
Bus control, timeout: Off
Pulse output
Heat sink cleaning warning, high
Comparator 0
Comparator 1
Comparator 2
Comparator 3
Comparator 4
Comparator 5
Logic rule 0
Logic rule 1
Logic rule 2
Description
This option is active when the actual
speed is above the speed reference
setting.
Control output via fieldbus. The state of
the output is set in parameter 5-90 Digital
& Relay Bus Control. The output state is
retained in the event of fieldbus timeout.
Control output via fieldbus. The state of
the output is set in parameter 5-90 Digital
& Relay Bus Control. When bus timeout
occurs, the output state is set high (On).
See parameter group 13-1* Comparators.
If comparator 0 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators.
If comparator 1 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators.
If comparator 2 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators.
If comparator 3 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators.
If comparator 4 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators.
If comparator 5 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-4* Logic Rules.
If logic rule 0 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-4* Logic Rules.
If logic rule 1 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
See parameter group 13-4* Logic Rules.
If logic rule 2 is evaluated as TRUE, the
output goes high. Otherwise, it is low.
AU275649936274en-001401 / 130R0507 |
127