Danfoss VLT AutomationDrive FC 360 Programming Manual page 238

Programming Guide | VLT® AutomationDrive FC 360
Option
[4]
[5]
14-15 Kin. Back-up Trip Recovery Level
Default value:
Size related
Setup:
All setups
Data type:
Uint32
This parameter specifies the kinetic back-up trip recovery level.
14-17 Fast Mains Phase Loss Level
Default value:
300%
Setup:
1 setup
Data type:
Uint16
Set this parameter to a lower value makes the detection more sensitive. Set this parameter to a higher value is opposite. This parameter is
only active when parameter 14-12 Response to Mains Imbalance selects option [4] Fast Trip or [5] Fast Warning.
14-18 Fast Mains Phase Loss Min Power
Default value:
10%
Setup:
1 setup
Data type:
Uint16
The fast detection does not activate if the actual power is lower than the percentage of parameter 14-18 Fast Mains Phase Loss Min
Power x P . This parameter is only active when parameter 14-12 Response to Mains Imbalance selects option [4] Fast Trip or [5] Fast
M, N
Warning.
14-2* Reset Functions
4.13.3
Parameters for configuring auto reset handling, special trip handling, and control card self-test, or initialization.
14-20 Reset Mode
Default value:
[0] Manual reset
Setup:
All setups
236
| Danfoss A/S © 2024.01
Name
Fast Trip
Fast Warning
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Description
Enable the fast detection to trip the
drive. This option is related to parameter
14-17 Fast Mains Phase Loss Level and
parameter 14-18 Fast Mains Phase Loss
Min Power.
Enable the fast detection to issue
a warning. This option is related to
parameter 14-17 Fast Mains Phase Loss
Level and parameter 14-18 Fast Mains
Phase Loss Min Power.
Range (0.000–500.000
ReferenceFeedbackUnit)
-3
True
Range (0–1000%)
0
True
Range (0–100%)
0
True
Option
–
AU275649936274en-001401 / 130R0507