Danfoss VLT AutomationDrive FC 360 Programming Manual page 126

Programming Guide | VLT® AutomationDrive FC 360
Option
[171]
[172]
[193]
[194]
5-31 Terminal 29 Digital Output
Default value:
[0] No operation
Setup:
All setups
Data type:
Uint8
Select the function to control the digital output.
Option
[0]
[1]
[2]
[3]
[4]
[5]
[6]
124
| Danfoss A/S © 2024.01
Name
Target Position Reached
Position Control Fault
Sleep Mode
Broken Belt Function
Parameter type:
Conversion index:
Change during operation:
Name
No operation
Control Ready
Drive ready
Drive rdy/rem ctrl
Stand-by/no warning
Running
Running/no warning
Description
The target position is reached. This option
is only effective when parameter 37-00
Application Mode is set to [2] Position
Control.
A fault occurred in the positioning
process. Refer to parameter 37-18 Pos.
Ctrl Fault Reason for details about the
fault. This option is only effective when
parameter 37-00 Application Mode is set
to [2] Position Control.
The drive/system has entered sleep mode.
See parameter group 22-4* Sleep Mode.
A broken belt condition has been
detected. See parameter group 22-4*
Sleep Mode.
Option
–
True
Description
Default for all digital outputs and relay
outputs.
The control card is ready.
The drive is ready for operation and
applies a supply signal on the control
board.
The drive is ready for operation and is in
auto-on mode.
Ready for operation. No start or stop
command is given (start/disable). No
warnings are active.
The motor is running and shaft torque is
present.
The motor is running and there are no
warnings.
AU275649936274en-001401 / 130R0507