Danfoss VLT AutomationDrive FC 360 Programming Manual page 54

Programming Guide | VLT® AutomationDrive FC 360
Option
[3]
[4]
1-1* Motor Selection
4.2.2
Parameter group for setting general motor data. This parameter group cannot be adjusted while the motor is running.
The active parameters are shown in the following table. x indicates that a particular parameter is active when the option is selected.
Table 12: Active Parameters
Parameter 1-10 Motor Construction
Parameter 1-00 Configuration Mode
Parameter 1-03 Torque Characteristics
Parameter 1-06 Clockwise Direction
Parameter 1-07 Motor Angle Offset Adjust
Parameter 1-08 Motor Control Bandwidth
Parameter 1-14 Damping Gain
Parameter 1-15 Low Speed Filter Time Const.
Parameter 1-16 High Speed Filter Time Const.
Parameter 1-17 Voltage Filter Time const.
Parameter 1-18 Min. Current at No Load
Parameter 1-20 Motor Power [kW]
Parameter 1-22 Motor Voltage
Parameter 1-23 Motor Frequency
Parameter 1-24 Motor Current
Parameter 1-25 Motor Nominal Speed
Parameter 1-26 Motor Cont. Rated Torque
Parameter 1-29 Automatic Motor Adaption (AMA)
Parameter 1-30 Stator Resistance (Rs)
Parameter 1-31 Rotor Resistance (Rr)
Parameter 1-33 Stator Leakage Reactance (X1)
Parameter 1-35 Main Reactance (Xh)
Parameter 1-37 d-axis Inductance (Ld)
Parameter 1-38 q-axis Inductance (Lq)
Parameter 1-39 Motor Poles
52
| Danfoss A/S © 2024.01
Name
Adaptive 1
Adaptive 2
[0] Asynchron
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Description
Optimized for smooth steady state
operation, with extra active damping.
Focus on low-inductance PM motors. This
option is an alternative to [3] Adaptive 1.
[1] PM, non salient SPM [3] PM, salient IPM
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x
x x
AU275649936274en-001401 / 130R0507