Danfoss VLT AutomationDrive FC 360 Programming Manual page 276

Programming Guide | VLT® AutomationDrive FC 360
Option
[0]
[1]
[2]
[7]
[8]
21-14 Ext. 1 Feedback Source
Default value:
[0] No function
Setup:
All setups
Data type:
Uint8
Define which input on the drive should be treated as the source of the feedback signal.
Option
[0]
[1]
[2]
[7]
[8]
21-15 Ext. 1 Setpoint
Default value:
0.000 ExtPID1Unit
Setup:
All setups
Data type:
Int32
This parameter is used as the reference for comparing feedback values. The setpoint can be offset with digital, analog, or bus references.
21-17 Ext. 1 Reference [Unit]
Default value:
0.000 ExtPID1Unit
Setup:
All setups
Data type:
Int32
Return the resulting reference value.
274
| Danfoss A/S © 2024.01
Name
No function
Analog Input 53
Analog Input 54
Frequency input 29
Frequency input 33
Parameter type:
Conversion index:
Change during operation:
Name
No function
Analog Input 53
Analog Input 54
Frequency input 29
Frequency input 33
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Option
–
True
Range (-999999.99
ExtPID1Unit–999999.999
ExtPID1Unit)
-3
True
Range (-999999.999–
999999.999 ExtPID1Unit)
-3
True
AU275649936274en-001401 / 130R0507