Danfoss VLT AutomationDrive FC 360 Programming Manual page 184

Programming Guide | VLT® AutomationDrive FC 360
Select the trigger for the setup selection.
Option
[0]
[1]
[2]
[3]
8-56 Preset Reference Select
Default value:
[3] Logic OR
Setup:
All setups
Data type:
Uint8
Select the trigger for the preset reference selection.
Option
[0]
[1]
[2]
[3]
8-57 PROFIdrive OFF2 Select
Default value:
[3] Logic OR
Setup:
All setups
Data type:
Uint8
Select control of the drive OFF2 selection via the terminals (digital input) and/or via the fieldbus. This parameter is active only when
parameter 8-01 Control Site is set to [0] Digital and ctrl. word and parameter 8-10 Control Word Profile is set to [1] PROFIdrive profile.
182
| Danfoss A/S © 2024.01
Name
Digital input
Bus
Logic AND
Logic OR
Parameter type:
Conversion index:
Change during operation:
Name
Digital input
Bus
Logic AND
Logic OR
Parameter type:
Conversion index:
Change during operation:
Description
A digital input triggers the setup
selection.
A serial communication port or the
fieldbus triggers the setup selection.
The fieldbus/serial communication port
and a digital input trigger the setup
selection.
The fieldbus/serial communication port or
a digital input triggers the setup selection.
Option
–
True
Description
A digital input triggers the preset
reference selection.
A serial communication port or the
fieldbus triggers the preset reference
selection.
The fieldbus/serial communication port
and a digital input trigger the preset
reference selection.
The fieldbus/serial communication port
or a digital input triggers the preset
reference selection.
Option
–
True
AU275649936274en-001401 / 130R0507