Danfoss VLT AutomationDrive FC 360 Programming Manual page 100

Programming Guide | VLT® AutomationDrive FC 360
3-90 Step Size
Default value:
0.10%
Setup:
All setups
Data type:
Uint16
Enter the increment size required for increase/decrease as a percentage of the synchronous motor speed, n
activated, the resulting reference is increased/decreased by the amount set in this parameter.
3-92 Power Restore
Default value:
[0] Off
Setup:
All setups
Data type:
Uint8
Reset or restore the Digital Potentiometer reference.
Option
[0]
[1]
3-93 Maximum Limit
Default value:
100%
Setup:
All setups
Data type:
Int16
Set the maximum allowed value for the resulting reference. This is recommended if the Digital Potentiometer is used for fine-tuning of
the resulting reference.
3-94 Minimum Limit
Default value:
-100%
Setup:
All setups
Data type:
Int16
Set the minimum allowed value for the resulting reference. This is recommended if the Digital Potentiometer is used for fine-tuning of
the resulting reference.
3-95 Ramp Delay
Default value:
1000 ms
Setup:
All setups
Data type:
Uint32
98
| Danfoss A/S © 2024.01
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Name
Off
On
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Range (0.01–200%)
-2
True
. If increase/decrease is
s
Option
–
True
Description
Reset the Digital Potentiometer reference
to 0% after power-up.
Restore the most recent Digital
Potentiometer power-up.
Range (-200–200%)
0
True
Range (-200–200%)
0
True
Range (0–3600000 ms)
0
True
AU275649936274en-001401 / 130R0507