Danfoss VLT AutomationDrive FC 360 Programming Manual page 274

Programming Guide | VLT® AutomationDrive FC 360
18-8* Compatibility
4.17.4
18-87 Inv. Max. Current
Default value:
0.00 A
Setup:
1 setup
Data type:
Uint32
View the inverter maximum current, which should match the nameplate data on the connected motor. The data are used for calculation
of torque, motor overload protection, and so on.
18-88 Motor current
Default value:
0.00 A
Setup:
1 setup
Data type:
Uint32
View the motor current measured as a mean value, IRMS. The value is filtered, and thus approximately 1.3 s may pass from when an input
value changes to when the data readout values change.
18-9* PID Readouts
4.17.5
18-90 Process PID Error
Default value:
0.0%
Setup:
All setups
Data type:
Int16
Give the present error value used by the Process PID Controller.
18-91 Process PID Output
Default value:
0.0%
Setup:
All setups
Data type:
Int16
Give the present raw output value from the Process PID Controller.
18-92 Process PID Clamped Output
Default value:
0.0%
Setup:
All setups
Data type:
Int16
Give the present output value from the Process PID Controller after the clamp limits have been observed.
18-93 Process PID Gain Scaled Output
Default value:
0.0%
Setup:
All setups
272
| Danfoss A/S © 2024.01
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Range (0.00–9999.99 A)
-2
True
Range (0.00–9999.99 A)
-2
True
Range (-200.0–200.0%)
-1
False
Range (-200.0–200.0%)
-1
False
Range (-200.0–200.0%)
-1
False
Range (-200.0–200.0%)
-1
AU275649936274en-001401 / 130R0507