Danfoss VLT AutomationDrive FC 360 Programming Manual page 182

Programming Guide | VLT® AutomationDrive FC 360
8-51 Quick Stop Select
Default value:
[3] Logic OR
Setup:
All setups
Data type:
Uint8
Select control of the quick stop function via the terminals (digital input) and/or via the bus.
Option
[0]
[1]
[2]
[3]
8-52 DC Brake Select
Default value:
[3] Logic OR
Setup:
All setups
Data type:
Uint8
Select control of the DC brake via the terminals (digital input) and/or via the bus.
When parameter 1-10 Motor Construction is set to [1] PM non-salient SPM, only selection [0] Digital input is available.
Option
[0]
[1]
[2]
[3]
180
| Danfoss A/S © 2024.01
Parameter type:
Conversion index:
Change during operation:
Name
Digital input
Bus
Logic AND
Logic OR
Parameter type:
Conversion index:
Change during operation:
NOTICE
Name
Digital input
Bus
Logic AND
Logic OR
Option
–
True
Description
Activate quick stop command via a digital
input.
Activate quick stop command via the
serial communication port or fieldbus
option.
Activate quick stop command via the
fieldbus/serial communication port and 1
extra digital input.
Activate quick stop command via the
fieldbus/serial communication port or via
1 of the digital inputs.
Option
–
True
Description
Activate DC brake command via a digital
input.
Activate DC brake command via the serial
communication port or fieldbus option.
Activate DC brake command via the
fieldbus/serial communication port and 1
extra digital input.
Activate DC brake command via the
fieldbus/serial communication port or via
1 of the digital inputs.
AU275649936274en-001401 / 130R0507