Danfoss VLT AutomationDrive FC 360 Programming Manual page 275

Programming Guide | VLT® AutomationDrive FC 360
Data type:
Int16
Give the present output value from the Process PID Controller after the clamp limits have been observed, and the calculated value has
been gain scaled.
Parameter Group 21-** Ext. Closed Loop
4.18
21-0* Ext. CL Autotuning
4.18.1
21-09 Extended PID Enable
Default value:
[0] Disabled
Setup:
All setups
Data type:
Uint8
Select the extended CL PID controller that is to be autotuned.
Option
[0]
[1]
21-1* Ext. CL 1 Ref./Fb.
4.18.2
21-11 Ext. 1 Minimum Reference
Default value:
0.000 ExtPID1Unit
Setup:
All setups
Data type:
Int32
Set the minimum value that can be obtained by the sum of the setpoint and reference.
21-12 Ext. 1 Maximum Reference
Default value:
100.000 ExtPID1Unit
Setup:
All setups
Data type:
Int32
Set the maximum value that can be obtained by the sum of the setpoint and reference.
21-13 Ext. 1 Reference Source
Default value:
[0] No function
Setup:
All setups
Data type:
Uint8
Define which input on the drive should be treated as the source of the reference signal.
Danfoss A/S © 2024.01
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Name
Disabled
Enabled Ext CL1 PID
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU275649936274en-001401 / 130R0507 |
False
Option
–
True
Range (-999999.999–
999999.999 ExtPID1Unit)
-3
True
Range (-999999.999–
999999.999 ExtPID1Unit)
-3
True
Option
–
True
273