Danfoss VLT AutomationDrive FC 360 Programming Manual page 240

Programming Guide | VLT® AutomationDrive FC 360
Option
[13]
[14]
14-21 Automatic Restart Time
Default value:
10 s
Setup:
All setups
Data type:
Uint16
Enter the time interval from trip to start of the automatic reset function. This parameter is active when parameter 14-20 Reset Mode is set
to [1]–[13] Automatic reset.
14-22 Operation Mode
Default value:
[0] Normal operation
Setup:
1 setup
Data type:
Uint8
Select the operation mode.
Option
[0]
[2]
14-24 Trip Delay at Current Limit
Default value:
60 s
Setup:
All setups
Data type:
Uint8
Enter the current limit trip delay in seconds. When the output current reaches the current limit (parameter 4-18 Current Limit), a warning
is triggered. When the current limit warning has been continuously present for the period specified in this parameter, the drive trips. To
run continuously in current limit without tripping, set the parameter to 60 s = Off. Thermal monitoring of the drive remains active.
14-25 Trip Delay at Torque Limit
Default value:
60 s
Setup:
All setups
Data type:
Uint8
238
| Danfoss A/S © 2024.01
Name
Infinite auto reset
Reset at power-up
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Name
Normal operation
Initialisation
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Select [13] Infinite Automatic Reset for
continuous resetting after tripping.
Range (0–600 s)
0
True
Option
–
True
Description
Normal operation with motor selected.
Reset parameter values to default settings.
The drive resets during the next power-
up.
Range (0–60 s)
0
True
Range (0–60 s)
0
True
AU275649936274en-001401 / 130R0507