Danfoss VLT AutomationDrive FC 360 Programming Manual page 127

Programming Guide | VLT® AutomationDrive FC 360
Option
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
Danfoss A/S © 2024.01
Name
Run in range/no warn
Run on ref/no warn
Alarm
Alarm or warning
At torque limit
Out of current range
Below current, low
Above current, high
Out of frequency range
Below frequency, low
Above frequency, high
Out of feedb. range
Below feedback, low
Above feedback, high
Thermal warning
Ready, no thermal warning
Description
The motor is running within the
programmed current and speed ranges
set in parameter 4-50 Warning Current
Low to parameter 4-51 Warning Current
High. There are no warnings.
The motor runs at reference speed. No
warnings.
An alarm activates the output.
An alarm or a warning activates the
output.
The torque limit set in parameter 4-16
Torque Limit Motor Mode, or parameter
4-17 Torque Limit Generator Mode has
been exceeded.
The motor current is outside the range set
in parameter 4-18 Current Limit.
The motor current is lower than set in
parameter 4-50 Warning Current Low.
The motor current is higher than set in
parameter 4-51 Warning Current High.
Output frequency is outside the frequency
range.
The output speed is lower than the setting
in parameter 4-40 Warning Freq. Low.
The output speed is higher than the
setting in parameter 4-41 Warning Freq.
High.
The feedback is outside the range set in
parameter 4-56 Warning Feedback Low
and parameter 4-57 Warning Feedback
High.
The feedback is below the limit set in
parameter 4-56 Warning Feedback Low.
The feedback is above the limit set in
parameter 4-57 Warning Feedback High.
The thermal warning turns on when the
temperature exceeds the limit in the
motor, the drive, the brake resistor, or the
thermistor.
The drive is ready for operation, and there
is no overtemperature warning.
AU275649936274en-001401 / 130R0507 |
125