Danfoss VLT AutomationDrive FC 360 Programming Manual page 86

Programming Guide | VLT® AutomationDrive FC 360
Set the Gain Boost Factor.
2-29 Torque Ramp Down Time
Default value:
0.0 s
Setup:
All setups
Data type:
Uint8
Set the torque ramp-down time.
2-3* Adv. Mech Brake
4.3.4
2-30 Position P Start Proportional Gain
Default value:
0.0000
Setup:
All setups
Data type:
Uint32
Enter the position controller during start proportional gain. Quick control is obtained at high amplification. However, if the amplification
is large, the process may become unstable.
2-31 Speed PID Start Proportional Gain
Default value:
0.015
Setup:
All setups
Data type:
Uint32
Enter the position controller during start proportional gain. Quick control is obtained at high amplification. However, if the amplification
is large, the process may become unstable.
2-32 Speed PID Start Integral Time
Default value:
200.0 ms
Setup:
All setups
Data type:
Uint32
Enter the speed controller integral time. Obtain quick control through a short integral time, if the integral time is short, the process
becomes unstable. An excessively long integral time disables the integral action.
2-33 Speed PID Start Lowpass Filter Time
Default value:
10.0 ms
Setup:
All setups
Data type:
Uint16
Set a time constant for the speed control low-pass filter. The low-pass filter improves steady-state performance and dampens oscillations
on the feedback signal. However, severe filtering can be detrimental to dynamic performance.
84
| Danfoss A/S © 2024.01
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Range (0.0–5.0 s)
-1
True
Range (0.0000–1.0000)
-4
True
Range (0.000 = Off–1.000)
-3
True
Range (1.0 ms–20000.0 = Off
ms)
-1
True
Range (0.1–100.0 ms)
-1
True
AU275649936274en-001401 / 130R0507