Danfoss VLT AutomationDrive FC 360 Programming Manual page 14
Hide thumbs
Also See for VLT AutomationDrive FC 360:
- Programming manual (164 pages) ,
- Design manual (146 pages) ,
- Quick manual (78 pages)
Table of Contents
Advertisement
Programming Guide | VLT® AutomationDrive FC 360
Figure 4: Grounding of Shielded/Armored Control Cables
Start/Stop
1.5.2
Make sure the drive is under the factory setting before doing the following operation.
Terminal 18 = Parameter 5-10 Terminal 18 Digital Input[8] Start.
Terminal 27 = Parameter 5-12 Terminal 27 Digital Input[0] No operation (default coast inverse).
12
| Danfoss A/S © 2024.01
NOTICE
AU275649936274en-001401 / 130R0507
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the VLT AutomationDrive FC 360 and is the answer not in the manual?
Questions and answers