Danfoss VLT AutomationDrive FC 360 Programming Manual page 252

Programming Guide | VLT® AutomationDrive FC 360
Data type:
Int16
View an extra description of the error. This parameter is mostly used with alarm 38, Internal Fault.
15-32 Alarm Log: Time
Default value:
0 s
Setup:
All setups
Data type:
Uint32
View the time when the logged event occurred. Time is measured in seconds from drive start-up.
15-4* Drive Identification
4.14.3
Parameters containing read-only information about the hardware and software configuration of the drive.
15-40 FC Type
Default value:
0
Setup:
1 setup
Data type:
VisStr
View the drive type. The readout is identical to the power field of the type code definition, characters 1–6.
15-41 Power Section
Default value:
0
Setup:
1 setup
Data type:
VisStr
View the power size of the drive. The readout is identical to the power field of the type code definition, characters 7–10.
15-42 Voltage
Default value:
0
Setup:
1 setup
Data type:
VisStr
View the mains voltage of the drive. The readout is identical to the power field type of the type code definition, characters 11–12.
15-43 Software Version
Default value:
0
Setup:
1 setup
Data type:
VisStr
View the combined software version (or package version) consisting of power software and control software.
250
| Danfoss A/S © 2024.01
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
True
Range (0–2147483647 s), Array
[10]
0
False
Range (0–7)
0
False
Range (0–20)
0
False
Range (0–20)
0
False
Range (0–20)
0
False
AU275649936274en-001401 / 130R0507