Delta AS Series Programming Manual page 96

Special auxiliary
relay
SM1155 ON: the trigger is enabled and the attachment is not found.
Retore parameters on Delta devices
SM1160-SM1161
SM1166 After the data exchange parameters are downloaded, the system is refreshed.
SM1167–SM1199 After the data exchange parameters are downloaded, you set the flag to ON or OFF.
SM1200–SM1263 ON: when the system is refreshed.
SM1269 ON: there is a socket configuration error.
SM1270–SM1353 The flag is refreshed when the socket function is executed.
SM1312–SM1315 The flag is ON, when the system is refreshed automatically.
After the data exchange parameters are downloaded through EtherNet/IP, you set the flag to ON
SM1375–SM1407
or OFF.
SM1408–SM1439 ON: an error occurred in data exchange through EtherNet/IP.
SM1440–SM1447 ON: a timeout occurred in the adapter of the I/O connection through EtherNet/IP.
ON: I/O connection is established through EtherNet/IP (Adapter).
SM1448~SM1455 OFF: I/O connection is NOT established through EtherNet/IP (Adapter) or the communication is
disconnected.
SM1581–SM1588 You set the flag to ON or OFF.
SM1601–SM1608 You set the flag to ON or OFF.
SM1611-SM1618 The system sets the flag to ON or OFF.
SM1621-SM1628 The system sets the flag to ON or OFF.
SM1631–SM1638 The system sets the flag to ON and you set it to OFF.
SM1641–SM1648 You set the flag to ON or OFF.
SM1651–SM1658 The system sets the flag to ON or OFF.
SM1661–SM1668 You set the flag to ON or OFF.
SM1671–SM1682 The system sets the flag to ON or OFF.
SM1683 The system sets the flag to ON or OFF.
SM1684—SM1685 You set the flag to ON or OFF.
SM1691-SM1698 The system sets the flag to ON or OFF.
SM1700-SM1705 The system sets the flag to ON or OFF.
SM1709–SM1710 You set the flag to ON or OFF.
SM1712–SM1743 You set the flag to ON or OFF.
SM1744–SM1807 The system sets the flag to ON or OFF.
SM1821–SM1822 You set the flag to ON or OFF.
SM1824–SM1855 You set the flag to ON or OFF.
SM1856–SM1919 The system sets the flag to ON or OFF.
2.2.9 Stepping Relays (S)
You can easily use the stepping relay in industrial automation to set a procedure. It is the most basic device in sequential
function chart (SFC) programming. Refer to the ISPSoft User Manual for more information on sequential function chart
programming.
There are 2048 stepping relays, (S0–S2047). Every stepping relay is like an output relay in that it has an output coil,
contact A, and contact B. You can use a stepping relay several times in a program, but the relay cannot directly drive the
external load. In addition, you can use the stepping relay as a general auxiliary relay when it is not used in a sequential
function chart.
Refresh time
Cha p ter 2 De vices
2 - 7 3
2_