Table of Contents
Advertisement
MITSUBISHI CNC
2 Monitor Screens
2.5.4 Changing the Display Mode
The graphics display mode includes the 1-plane, 2-plane and 3D mode. When the menu [Display mode] is pressed and
the following display mode menu is selected, the axis configuration of each plane changes, and the menu display returns
to the original state. It is also possible to change the display mode by setting the axis name to the input area.
(Note 1) When display mode is changed, the graphic data displayed up to that point are erased.
(Note 2) The set display mode is held even after the power is turned OFF and ON.
(Note 3) The display mode can be set independently for the trace function and program check function. These settings
are not sequenced.
(Note 4) The menu axis names XYZ correspond to the base axis IJK. X = base axis I, Y = base axis J, and Z = base
axis K.
Display mode menus
Menu
XY
YZ
XZ
XY/XZ
YX/YZ
XYZ
Operation method (Changing the display mode)
(1)
Press the menu [Display mode].
Select the mode to display and press the menu.
(2)
(Example) [XY/XZ]
I - 74
This changes to the 1-plane display mode configured of X-Y.
The X axis is displayed as the horizontal axis, and the Y axis is displayed
as the vertical axis.
This changes to the 1-plane display mode configured of Y-Z.
The Y axis is displayed as the horizontal axis, and the Z axis is displayed
as the vertical axis.
This changes to the 1-plane display mode configured of X-Z.
The X axis is displayed as the horizontal axis, and the Z axis is displayed
as the vertical axis.
This changes to the 2-plane display mode configured of X-Y and X-Z.
The X axis is displayed as the horizontal axis, and the Y axis and Z axis
are displayed as the vertical axis.
This changes to the 2-plane display mode configured of Y-X and Y-Z.
The Y axis is displayed as the horizontal axis, and the X axis and Z axis
are displayed as the vertical axis.
This changes to the 3D display mode.
A cube is displayed on the lower right of the screen.
Details
The menus for the selectable display modes appear.
The input area appears.
The display mode and drawing area appear as a 2-plane
image.
Type
C
C
C
C
C
C
Advertisement
Table of Contents
